EuroLED® Rear Fog Lamp - ECE
Low profile round LED rear fog lamp with single LED and clear lens. Optic appears clear until illuminated.
Rollover/tap the icons below for further details:
Fit and Forget
Fit and Forget by Design means every aspect, material and component of this lamp has been carefully chosen to ensure longevity in the most demanding environmental conditions.
Multivolt™ for optimum performance in 12 and 24 volt systems.
Product has been type approved to all relevant UN ECE Regulations to allow use on Australian and New Zealand roads.
High Impact Acrylic Lens Material
This specially formulated high impact acrylic (PMMA) offers enhanced resistance against long term UV-exposure and commonly used chemical washes, liquids, etc.
Ultra Wide Visibility Optics
These lamps far exceed the minimum legal brightness requirement, and are much more noticeable to following drivers particularly as the vehicle in front turns and the stop or turn signal is viewed from an angle.
GGVSEB (previously GGVS) stands for the German regulation on carriage of dangerous goods by road, rail and inland waterway.
HELLA New Zealand LED lamps are designed to withstand harsh environmental conditions and will tolerate long term exposure to high UV levels without fading or embrittlement.
5 Year Warranty
This LED based lighting product carries a 5-year warranty covering faults in materials, components or workmanship. Please refer to HELLA’s full terms and conditions.
Made in New Zealand
Two hole surface mount with mounting bushes supplied.
Multivolt™ for optimum brightness at input voltages from 9 to 33 volts.
Pre-wired with 2.5m of cable of sheathed multi-core cable.
Fog lamp lens is clear when not active.
|2NE 959 821-2xx_Instruc_EuroLED130_Rear_Fog.pdf